How A Typical Hardwood Flooring Installation Will Go

Hardwood flooring is a beautiful addition to your home. If properly cared for, it will last your lifetime and then some. At the very least, it will last beyond the point where you have paid off your mortgage. If you have decided to purchase and have residential hardwood flooring installed, here is how the process typically goes. 

Remove Everything from the Room or Hallway

With the exception of objects that are permanently attached to the walls and floor, everything else in the project room or hallway has to be removed. There should be nothing left on the current floor, including furniture, tables, bookshelves, etc.. By removing everything that can be removed, you make the job that much easier for the installation crew. If you also want any old carpet and carpet pad removed from the floor, be sure to remove that, or the installation crew may just install the hardwood flooring over the top of the old carpet. 

The Crew Starts by Installing the Soundproofing Pad

Hardwood floors require a soundproofing pad underneath the planks so that every footfall does not sound like an earthquake when you are in another part of the house. This pad is usually some shade of gray and looks like thick woolen cloth with other fibers mixed into it. It is rolled out from door to door, and wall to wall. Then it is cut to fit around baseboards and the posts of doorways. Once the padding is secure with a few staples around the edges of the room or hallway, the wood floor is next. 

Running the Planks a Certain Direction

You can choose to run planks the length of the room or hallway, or run the planks the width of the room or hallway. The look is very different depending on which you choose, and the planks are cut differently, too. Once you choose the direction of the planks, the crew begins to cut and lay boards over the soundproof padding, taking care to stagger the boards so that they are not all the same length and not all fitting the exact same way. It is akin to laying bricks; you never want several bricks or boards to be stacked right on top of each other because it weakens the brick wall or weakens the hardwood floor. 

Nailing in the Boards

Every couple of feet of boards, the crew stops, snap-locks the boards in place, and then uses a brad nailer to nail the boards to the floor. If they make a mistake, they have to rip up a row or two to fix it, but this is rare. This system of cutting, laying, locking, and nailing a few feet of flooring at a time continues until the entire floor is complete.  For more information, check out companies like Blair & Sons Floor Co

Share